Home / Tools & Rates / Geberit Battery Crimper

Geberit Battery Crimper Hire — Cape Town

Battery-powered Mepla pressing — two units: Killarney Gardens (26–40mm) and Bergvliet (16–32mm).

Geberit battery press tool for Mepla pipe — hire in Cape Town

About this tool

The professional way to press Geberit Mepla multilayer pipe — no hand strength needed, consistent factory-spec crimps, much faster on multi-joint jobs. We run two units so there's one near you: Killarney Gardens covers 26–40mm, Bergvliet covers 16–32mm.

R550per day · same day collection / next day delivery (charges may apply)
Book This Tool ↓

Fittings & extras you'll likely need

What to have on the bakkie so the hire day isn't wasted.

Geberit Mepla pipeMultilayer pipe in 26 / 32 / 40mm to suit the job.
Mepla press fittingsElbows, tees, couplings, reducers and wall plates in matching sizes.
Threaded adaptorsMepla-to-male/female iron adaptors for connecting to geysers, valves and existing pipework.
Pipe cutter & reamerSquare cuts and chamfered ends are essential for a sound press joint.
💡 Not sure on sizes or fittings? Call us on 073 701 7408 before you collect — phone support is part of the service.

On the job

The press tool, the kit and the Mepla system it presses.

How to use it — step by step

An easy guide to get it right first time. Full support on the phone if you get stuck.

  1. Cut the pipe squareUse a proper pipe cutter — never a hacksaw at an angle.
  2. Ream and calibrate the endDeburr and round the pipe end so the fitting slides on fully without scoring the O-ring.
  3. Insert to full depthPush the pipe into the fitting until it shows in the witness/inspection window.
  4. Load the correct jawFit the 26/32/40mm jaw to match the fitting size.
  5. Press the jointSeat the jaw square on the fitting and run the full press cycle — the tool completes automatically.
  6. Check the crimpConfirm the pressed profile is even all the way round before closing up.