Home / Tools & Rates / Ginde / Valsir / Rifeng Crimper

Ginde / Valsir / Rifeng Crimper Hire — Cape Town

Press tool for Rifeng, Valsir and Ginde multilayer pipe — 16mm to 25mm.

Valsir Pexal press fittings for the pex crimper — hire in Cape Town

About this tool

One crimper, three systems. Covers 16mm to 25mm on Rifeng, Valsir (Pexal / Mixal) and Ginde multilayer pipe — fast, flame-free press joints for hot and cold reticulation. With the crimper on day hire you can take on any of these systems without buying the tool.

R300per day · same day collection / next day delivery (charges may apply)
Book This Tool ↓

Fittings & extras you'll likely need

What to have on the bakkie so the hire day isn't wasted.

Valsir Pexal / Mixal pipeMultilayer pipe in the sizes your job calls for.
Valsir press fittingsElbows, tees, couplings and reducers in matching sizes.
Threaded transition fittingsAdaptors to tie into geysers, valves and existing pipework.
Pipe cutter & calibratorSquare cuts and calibrated ends protect the fitting O-rings.
💡 Not sure on sizes or fittings? Call us on 073 701 7408 before you collect — phone support is part of the service.

On the job

The Valsir Pexal system — pipe, fittings and installations.

How to use it — step by step

An easy guide to get it right first time. Full support on the phone if you get stuck.

  1. Cut the pipe squareUse a proper cutter for a clean, straight end.
  2. Calibrate and deburrRound the end and chamfer it so it slides over the O-rings without damage.
  3. Insert to the witness holePush the pipe fully into the Valsir fitting — check the sight hole.
  4. Fit the matching jawMatch the press jaw to the fitting size.
  5. Press through the full cycleKeep the jaw square on the fitting and complete the stroke.
  6. Inspect the jointConfirm an even press profile before closing up.