Home / Tools & Rates / Geberit Pipe Bender

Geberit Pipe Bender Hire — Cape Town

Hand bending unit for Geberit Mepla pipe — 16mm, 20mm, 26mm and 32mm.

Geberit hand bending unit for Mepla pipe — hire in Cape Town

About this tool

Clean, kink-free bends in Mepla multilayer pipe without fittings. The Geberit hand bending unit comes cased with bending formers for 16mm, 20mm, 26mm and 32mm — fewer joints, faster runs, neater work on exposed pipe. Pairs perfectly with the battery crimper or hand crimper set.

R200per day · same day collection / next day delivery (charges may apply)
Book This Tool ↓

Fittings & extras you'll likely need

What to have on the bakkie so the hire day isn't wasted.

Geberit Mepla pipeMultilayer pipe in the sizes you're bending.
Tape measure & markerSet out bend positions accurately before you bend.
Pipe cutterSquare ends for the joints at each end of the run.
Pipe clipsSupport the finished run at correct centres.
💡 Not sure on sizes or fittings? Call us on 073 701 7408 before you collect — phone support is part of the service.

On the job

The bending unit, formers and Mepla pipe.

How to use it — step by step

An easy guide to get it right first time. Full support on the phone if you get stuck.

  1. Mark the bend positionMeasure and mark where the centre of the bend must sit.
  2. Select the correct formerMatch the bending former to the pipe size (16/20/26/32mm).
  3. Load the pipeSeat the pipe in the former with your mark aligned.
  4. Bend smoothlyPull through in one steady motion to the angle you need — the former prevents kinks.
  5. Check the angleOffer the bend up to the wall or fitting and fine-tune if needed.
  6. Continue the runFewer fittings, fewer joints — press only where you must.